This is on my firmware list. Wayne
---- http://www.elecraft.com On Dec 7, 2009, at 1:25 PM, Ian White GM3SEK <[email protected]> wrote: > Joe Subich, W4TV wrote: >> >> Ian, >> >>> If this area of code is to be revisited, the gap in available power >>> settings on 50MHz also needs to be addressed. >>> >>> The maximum available power without the KPA3 is 8W on 50MHz, but the >>> minimum available power with the KPA3 activates is about 13W >>> - a jump of more than 60%. >> >> The "gap" is not a matter of code, it is a matter of the power >> available from the LPA on six meters. The LPA can not make more >> than about 8 watts and stay "clean." However, the gain (ca. 12 dB) >> of the HPA is such that 13W is a minimum practical output. This >> leaves the gap. >> > > Only the lower end of the gap, 8W, is a hardware limitation. The upper > end of the gap, 13W, is set by DSP. ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
