Bill Davis Jr wrote:
>
>
> Started using HRD 4.1 build 2321 and with my K3. When trying to use it
> with the 10Ghz transverter the frequency display on HRD is "bogus" and
> freq control fails. So does HRD have an upper feq limit. Worked ok on
> 1296Mhz, one digit less.
>
>
I don't know the answer to that but it would be easy to check. Set the rig
to 10GHz then open the K3 Utility go to the Terminal page and send the
command FA; This is the command HRD would use to get the rig's frequency.
You should get a response FA followed by an 11 digit number, the frequency
in Hz. If the frequency is correct, HRD is not displaying it correctly.
-----
Julian, G4ILO. K2 #392 K3 #222.
* G4ILO's Shack - http://www.g4ilo.com
* KComm - http://www.g4ilo.com/kcomm.html
* KTune - http://www.g4ilo.com/ktune.html
--
View this message in context:
http://n2.nabble.com/K3-Ham-Radio-Deluxe-question-tp4173651p4174684.html
Sent from the Elecraft mailing list archive at Nabble.com.
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
