I have the same issue. It was working just fine now it isn't. Maybe the old code was used for the new GUI.
Bill K9YEQ K2-#35 (2 more), KX1-#35, K3, TS2000, IC7000, etc. > Date: Thu, 17 Dec 2009 20:54:22 -0800 > From: [email protected] > To: [email protected] > Subject: [Elecraft] W2 trouble > > I'm using a W2 with two sensors, both HF-2KW. I have the .92 firmware > installed, and I've been using the new W2 app. I am now getting some strange > behavior with the W2. First, sending QSK CW the lights keep flashing after > I've stopped transmitting, fainter and fainter with each flash and fewer LEDs > lighting up. This "echo" looks very strange while sending CW. I've tried > changing every parameter in the W2 app but it does not help. I've > disconnected the serial cable at both ends, killed the app, it doesn't > matter--I still get the echo, both at 100w and KW levels. > > Even worse, when I click on the SETTINGS tab in the W2 app the K3 starts > randomly transmitting (its in CW mode, VOX on). I don't see how this could > be, unless it is a computer problem. I am using a serial PCMCIA card that > gives me COM13 and COM14--COM13 goes to the W2 and COM14 goes to the K3. Any > help? > > 73, WD6DBM Eric > ______________________________________________________________ > Elecraft mailing list > Home: http://mailman.qth.net/mailman/listinfo/elecraft > Help: http://mailman.qth.net/mmfaq.htm > Post: mailto:[email protected] > > This list hosted by: http://www.qsl.net > Please help support this email list: http://www.qsl.net/donate.html _________________________________________________________________ Hotmail: Free, trusted and rich email service. http://clk.atdmt.com/GBL/go/171222984/direct/01/ ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
