JayR wrote:
>
> Is there a simple way to reset all the configuration parameters to the
> factory defaults
> with out going through each item?
>
> Jay
>
You can reset everything by the following:
Power off
Hold in shift knob while pressing power on switch unit it fully powers up
You will have to start over again just like you had just finished building
it - so don't so this just for grins.
If you have an older configuration file saved you can reload it and be right
back where you were when you saved the file. The firmware is not affected
either way - kinda like a restore point in Win XP.
Good luck!
Gill
--
View this message in context:
http://n2.nabble.com/K3-Configuration-Reset-tp4211431p4211553.html
Sent from the Elecraft mailing list archive at Nabble.com.
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
