KA9UCP writes: >One point they did make, be sure the IC under the LCD is checked for >proper soldering as any corrections after the LCD is installed is a >"bear".
W3FPR writes: >The problem was that for a period of time, the leads on the backlight >assembly from the vendor were too short, and those backlight assemblies >with short leads must use the instructions on the errata page Gentlemen, Your recommendations are appreciated. I checked the IC joints VERY carefully for cold joints and bridges. I reflowed all joints as well. My leads are long as well. I have a followup question. The instructions specifically say NOT to remove the backing on either side. My LCD backlight assembly has white diffusers on both sides (so far so good). There is, however a SECOND thin plastic translucent (not white) film as well on top of the assembly which seems to be removable. Can I remove this second film? tnx. Conway Yee, N2JWQ ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
