Well so I've ordered a set of Wiha Driver-Loc drivers. I got the ESD-Safe handle and a set of bits for pretty much everything I use.
Ok with that taken care of I ordered replacement split washers, inside tooth washers, black and nickel screws and new standoffs. I also ordered the stainless steel screw kit. I take this K3 to the Oregon coast (pretty much literally to the beach) for FD every year.. So the stainless screws didn't seem like that bad of an idea (and it gets me new screws for the bottom of the unit)... I'll use a bit of heat to remove the screws with loc-tite on them and I'll rebuild the thing w/o the loc-tite. I think I'm also going to make some copper tape discs to put around the screw holes where the boards traces have been scratched. I'll probably solder the discs to the board around their outside to ensure good grounding. Figured while I was in there I ordered the Rev. D DSP board and I'll get that all updated. With all that and the P3 FD should be fun this year... ;) Thanks all ~Brett ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
