Roger, I think you may be experiencing the problem I had which I asked about yesterday subject: Re: [Elecraft] K3 Firmware update question - k3fw3r68
Check your ports with the elecraft utility, I had the same kind of issue and I needed to find an open port that gave me 4800 bps. I never had the problem before after an update to a new version. Perhaps you've just updated? Or perhaps your port is active to a different application using the port you had assigned in the utility at a prior time? Gary KA1J > Hi all, > > I can't work out why my K3 has stopped communicating with my PC. Besides > the K3 utility I'm using HRD. Up to now I've used the KUSB which has > worked fine, it was bought with K3 #191 at the same time. I reinstalled > the drivers checked Baud rate (38400), swapped ports etc but still no go. > > I then tried a standard RS232 instead, but still it does not work. > > What am I missing here? Any help would be appreciated (my email is set > to digest mode). > > 73 > Roger MW0IDX > > K3 #191 > K2 #2724 > KX1 #416 > > > > > ______________________________________________________________ > Elecraft mailing list > Home: http://mailman.qth.net/mailman/listinfo/elecraft > Help: http://mailman.qth.net/mmfaq.htm > Post: mailto:[email protected] > > This list hosted by: http://www.qsl.net > Please help support this email list: http://www.qsl.net/donate.html > ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
