The most obvious question: Did you set CONFIG:KRX3 to "Ant=bnc" or "Ant=Atu"? (as opposed to "not inSt")
73 -- Joe KB8AP On Jan 10, 2010, at 5:58 PM, <[email protected]> wrote: > I've just finished installing a KRX3 with the KBPF3 and when I push > the sub button it tells me "NO SUB". I have been through the menus > several > times, setting up the filters and modes and bandwidths for the main > and the > sub receiver but I still get the same error when I try to select the > sub > receiver. I have also selected the KBPF3 for the sub receiver, but it > doesn't ask me about setting up the KBPF3 for the sub. I assumed you > would > have to tell it when to use the KBPF3 as with the other filters. > Maybe this > is done automatically when going outside the amateur bands. I seem > to recall > something about this. > > I'm sure I have missed something. Can someone help? This is the very > first time I have installed something in the K3 (or the K2) that > didn't > work. > > Still looking through the manual, > > > Stan Rife > W5EWA > > > > > ______________________________________________________________ > Elecraft mailing list > Home: http://mailman.qth.net/mailman/listinfo/elecraft > Help: http://mailman.qth.net/mmfaq.htm > Post: mailto:[email protected] > > This list hosted by: http://www.qsl.net > Please help support this email list: http://www.qsl.net/donate.html ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
