Hi Jacques, Which sensor do you have? The 2W range is not available with the 2KW sensor.
The flashing SWR LED's indicates a SWR Alarm state. This happens when the W2's SWR Alarm is turned on and the SWR is excessively high. You can use the W2 Utility or the W2 Interface software to turn the SWR alarm off. Sending an 'A' command will toggle the alarm on and off. It takes a power cycle to restore the W2 to normal operation once a SWR alarm occurs. Be sure to use the W2 Utility to load the most current firmware, v 0.94. Hope this helps. 73, David, W4SMT --- On Wed, 1/13/10, f9oj.7 <[email protected]> wrote: > Hello > I assembled a W2 wattmeter last december, but I had to > spend a couple of > weeks in a clinic, and when back home, I tested it, but it > did work as it > ought to ! > > When "power" on, no problem ; when tapping"range", the 2 > watt led never > lights up. The others do normally. > > If I apply RF via the K3, the whole line of the "power" > green leds lights > up, whatever power applied, and the SWR line flickers > all over the range. > > Has anyone an idea? > > Thanks for any suggestion. > > Best 73 > > Jacques de F9OJ > K2 #O937 K3 # 2450 ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
