Paul, Yes, those are OK. They are the DOT and DASH lines to the microprocessor and have nothing else but U6 on the Control Board to bring the resistance down.
In general, a 10% deviation from the values listed in the manual are close enough. 73, Don W3FPR Paul Huff wrote: > Hi everybody, > > I recently started building a K2 and I've just finished the assembly of the > control board. My resistance checks are all within specs except two of them > are > just a little bit off. My readings at pins 29 and 30 of U6 are a little bit > higher than those listed in the table. (I'm getting about 96.3 K and the > table > lists 70-90 K.) I think that these readings are probably OK, but I thought > that > I would ask someone who has "been there and done that." Is there any need to > be > concerned about these checks? > > Thanks in advance and 73, > Paul - N8XMS > > ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
