When looking at this Barry I thought maybe you could read the status of the "+" icon on the LCD. That is supposed to be on if ESSB is on. I think a bug got into the FW where the icon is no longer showing when in ESSB.
This is from the current Programmer's manual... IC * (Misc. Icons and Status; GET only) RSP format: ICabcde; where abcde are ASCII characters (Byte in Table 4 below) used as collections flags (Bit in table). Each flag represents the status of an LCD icon and/or specific transceiver function. Some functions whose status is indicated by IC command flags can be controlled using emulation commands. For example, the K3 can be put into TX TEST by sending SWH18. The condition can be verified at any time using the IC command (byte a, bit 5). Another example: ESSB (extended SSB) can be turned on/off using an MN (menu) command, followed by SWT11, simulating a tap of 1 on the keypad. Again, IC can be used to verify the present state (byte d, bit 5). 73 Greg AB7R On 1/17/2010 12:35 PM, Barry N1EU wrote: > Can someone please confirm: it is possible to toggle the TX ESSB on/off > value via macro (mn096;swt11;mn255;) but it is impossible to set it to a > known value of "on" or "off" ? > > Thanks/73, > Barry N1EU > > > > > No virus found in this incoming message. > Checked by AVG - www.avg.com > Version: 8.5.432 / Virus Database: 270.14.147/2628 - Release Date: 01/17/10 > 07:35:00 > > ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
