Don, >From the new firmware release notes:
> Other new features and improvements: > > * NR (NOISE REDUCTION) ON/OFF: This is now saved > on a per-band/per-receiver basis (same as NB). NR ADJ > (noise reduction setting) is stored independently for > each mode. I haven't loaded the beta firmware but that says it should be possible to set different NR and NB values for each receiver. 73, ... Joe, W4TV > -----Original Message----- > From: [email protected] > [mailto:[email protected]] On Behalf Of Don Wilhelm > Sent: Tuesday, January 26, 2010 12:38 AM > To: Jim Miller > Cc: Elecraft Reflector > Subject: Re: [Elecraft] NR adjust on sub? > > > Jim, > > Contrary to what the manual says, the state of NR is the same > for both > the Main RX and the SUB. > Wayne has indicated that the manual is not correct in this particular > aspect and will be corrected in the next manual revision. > > 73, > Don W3FPR. > > Jim Miller wrote: > > I've activated Bset but when I hold the NR button I don't > get a Fx-x > > indication for setting the Sub NR. > > > > Didn't see anything in the manual or scanning throught the Config > > settings. > > > > How is this done? > > > > tnx > > > > jim ab3cv (sub newbie) > > > > > ______________________________________________________________ > Elecraft mailing list > Home: http://mailman.qth.net/mailman/listinfo/elecraft > Help: http://mailman.qth.net/mmfaq.htm > Post: mailto:[email protected] > > This list hosted by: http://www.qsl.net > Please help support this email list: http://www.qsl.net/donate.html ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
