Gary, Did you solder the wire from the "E" pad on the KXB3080 board to the correct via hole? Check carefully, then double check and triple check. Also, is the firmware chip fully seated? The narrow part of the leads should be fully into the socket. It takes a good deal of force to seat it - put both thumbs on the chip and fingers under the board and press until it is seated.
73, Don W3FPR Gary Swain wrote: > ive just fitted 30/80 board & its working great but the left hand number on > the display keeps flashig up a number "8" it is also usually brighter than > the other 2 figures in the display. Anyone have any ideas on where ive gone > wrong? > > Thanks, Gary, 2E0BFJ > ______________________________________________________________ > Elecraft mailing list > Home: http://mailman.qth.net/mailman/listinfo/elecraft > Help: http://mailman.qth.net/mmfaq.htm > Post: mailto:[email protected] > > This list hosted by: http://www.qsl.net > Please help support this email list: http://www.qsl.net/donate.html > ------------------------------------------------------------------------ > > > No virus found in this incoming message. > Checked by AVG - www.avg.com > Version: 9.0.733 / Virus Database: 271.1.1/2669 - Release Date: 02/05/10 > 02:35:00 > > ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
