I always shut down LP-BRIDGE, a virtual port program used for sharing the K3 serial port, before starting up the K3 utility. If memory serves, this was addressed early on and recommended.
Monty K2DLJ > > I can recall seeing this a couple of times, but not recently. The utility > does open the com port and try to interrogate the radio to find out what > firmware is installed, regardless of whether you use it for anything. The > problem may be related to using the VSPE virtual serial port software, > since > that's what I was using when I noticed the problem. > > ----- > Julian, G4ILO. K2 #392 K3 #222. > * G4ILO's Shack - http://www.g4ilo.com > * KComm - http://www.g4ilo.com/kcomm.html > * KTune - http://www.g4ilo.com/ktune.html > > -- > View this message in context: > http://n2.nabble.com/K3-Utility-program-issue-tp4526033p4526519.html > Sent from the Elecraft mailing list archive at Nabble.com. > ______________________________________________________________ > Elecraft mailing list > Home: http://mailman.qth.net/mailman/listinfo/elecraft > Help: http://mailman.qth.net/mmfaq.htm > Post: mailto:[email protected] > > This list hosted by: http://www.qsl.net > Please help support this email list: http://www.qsl.net/donate.html ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
