The K3 Utility finds the K3 at the speed it is set to (see the K3 CONFIG menu, RS232).
It does this by polling at all four of the supported K3 speeds. During firmware load the K3 Utility changes the speed to 38400 bps and then restores it to the original speed after a successful firmware load. It's not described in great detail because you don't need to do anything to pick any particular speed. Dick, K6KR -----Original Message----- From: [email protected] [mailto:[email protected]] On Behalf Of rrkrr Sent: Sunday, February 07, 2010 3:44 PM To: Elecraft Reflector Subject: [Elecraft] Elecraft K3 utility - RS-232 port speed? I have downloaded the Elecraft K3 utility and have it running on my Ubuntu computer. The utility communicates with the K3 and sees the firmware version I presently have as 2.7. Right now the serial port speed on my computer is 9600 baud. However, I can't find a recommended port speed to use for the firmware upgrade in the K3 utility documentation. Can someone clue me in? Bob K4ERR ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
