I dusted off my old K2 recently and decided to try to wire up an electret mic and give SSB a try--I've had the SSB module since I built the K2 years ago, but just never used it, because I had no mic at the time. I've discovered that when I ground the PTT line with the K2 in LSB or USB mode, I get the "Hi Cur" message, and my output power goes to well over 15W, regardless of the setting of the power output control.
I've done some of the voltage checks recommended in the SSB module manual, but only those for RX mode--I'm a little nervous about trying to measure voltages in transmit mode, because I don't know how long the PA can take that kind of current, and I don't want to fritz the final or cause other problems. There are some voltage discrepancies associated with U2--pin 5 on that device is supposed to have 0.6v in RX mode, but I'm seeing more like 2.5v. Pin 3 of U4--same story. If anyone out there has any suggestions for where to look for problems, or how to do further testing, I'm all ears. I found an old thread in the list archives that suggested replacing Q3 and/or Q4 on the K2 control board, in case one of those 2N7000s happened to take a static electricity hit, but I haven't had a chance to do that yet (don't have any 7000s lying around), and I'm somewhat hesitant to go down that path because this rig seems to work just fine in CW mode. Many thanks, Doug -- Doug Heacock AA0MS ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
