Let me describe better what I'm trying to do. When correctly commanded, the KDSP2 will first display version info
DSP 3.16 and then 2 seconds later will display CTL 3.10 (The version numbers are made up - I'm at work now.) What I had hoped to do was send a DS to retrieve the display state and get the 'DSP ...' string. Then 2000 ms later, send a second DS to get the display at that point. What happens, though, is that no matter how I adjust the timing, I can only get the final 'CTL 3.10' display but nothing when I had hoped to retrieve the 'DSP 3.16'. Or, I can get only the 'DSP 3.16' and not the CTL display. Is it possible to do what I'm trying to do? Or is the 2 s delay still part of a single K2 display that can't be retrieved via two DS commands? Thanks, Mike ab3ap On 02/15/2010 02:18 PM, Mike Markowski wrote: > I'm trying to write a snippet of code that will grab the KDSP2 firmware > revisions of the DSP and KDSP2 controller. The problem I have is that I > can't seem to grab both of these strings using a DS command. > > After sending the appropriate commands to have the version info > displayed, first the DSP flash firmware is shown, then 2 seconds later > the microcontroller firmware version. But I can never retrieve both > strings via the KIO2. Should it be possible to send a DS twice > (properly timed) during that display to get each string? > > Thanks and 73, > Mike ab3ap ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
