Has there been a change in the way the K3 KY command works recently? In CW mode it is not normally necessary to send TX; before using the KY command to send CW as TX is activated by enabling VOX which is the normal situation for QSK operation. In FSK D or PSK D however I am sure that it was always necessary to use TX; to start sending and RX; when you were finished, which makes sense as VOX is not normally used in these modes.
Today I found that when sending TX; the K3 goes into sending an idle sequence and never starts sending the text contained in the KY commands. By chance I found that if you don't send TX; even if VOX is not enabled, the transceiver does go into TX and begin sending the text as soon as a KY command is sent. Is this the way the command is supposed to work, or has something changed since the last time I used it? The K3 Programmers Reference says nothing about whether the K3 needs to be put into TX mode before sending in this way so I have just found what worked using trial and error and assumed that's how you are supposed to do it. ----- Julian, G4ILO. K2 #392 K3 #222. * G4ILO's Shack - http://www.g4ilo.com * KComm - http://www.g4ilo.com/kcomm.html * KTune - http://www.g4ilo.com/ktune.html -- View this message in context: http://n2.nabble.com/K3-KY-Command-tp4593734p4593734.html Sent from the Elecraft mailing list archive at Nabble.com. ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
