Jude, No upgrades are necessary, and the only mod kit available from Elecraft is the KX1PWRMODKT. If that KX1 has the KXB3080 option installed, the power mod may have already been installed (the KXB3080 kit also contains the KX1PWRMODKT) - download the instructions for the power mod kit and look at the values of the 2 resistors that are changed with the mod.
The KX1 power output is highly dependent on the power supply voltage, and typical is between 3.5 and 4 watts with a 13.8 volt power source. The transmit frequency is limited to the ham bands by the firmware. You would have to convince Wayne of the need to make a change to the KX1 firmware. 73, Don W3FPR Jude Miller wrote: > Just purchased a KX1 with a serial number of 1396. (BTW - I want to > buy a few more used units!) > > Should anything be upgraded on the KX1 since it's original build? The > power output is lower than advertised. I've been going through the > list messages as time permits and are finding bits of info. > > One additional question: what is required to allow the KX1 to tranmit > out of the Amateur freq. range? Would love to have access to addition > frequencies in the event of an emergency. > > ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
