You look at page 69 in the Elecraft K3 Owners Manual http://www.elecraft.com/manual/K3_Owner%27s_Manual_Rev_D6sm.pdf
~Brett On Tue, 2010-03-23 at 17:12 -0600, david feldman wrote: > Partially fixed - I had set XV1 ADR to TRN1 instead of INT TRN1. > > Once I changed that, I found many problems corrected - I was able to set the > two offset frequencies, I hear the relay switching between band segments, and > I am now able to receive on 2M. > > However, I repeated the calibration using the K3 utility and I still get this > message: > > 5 watt calibration succeeded > IsSamplingComplete: Unexpected response "DB 0.52 MW;" to "DB;" State 153 > 1 milliwatt calibration failed > > and after the calibration is done, I see the following on the display. > > ERR TXG > > How do I interpret this message? > > I'm much closer now thanks to the quick help! > > 73 Dave WB0GAZ [email protected] > _________________________________________________________________ > Hotmail: Trusted email with Microsoft’s powerful SPAM protection. > http://clk.atdmt.com/GBL/go/210850552/direct/01/ > ______________________________________________________________ > Elecraft mailing list > Home: http://mailman.qth.net/mailman/listinfo/elecraft > Help: http://mailman.qth.net/mmfaq.htm > Post: mailto:[email protected] > > This list hosted by: http://www.qsl.net > Please help support this email list: http://www.qsl.net/donate.html ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
