Mike, You will need all 4-40 x 3/16 pan head screws for the bottom cover and bottom of the front panel (longer ones can bottom out). I recall the proper number is 8, so look on the floor for the lost screw. Find out where you used a 3/16 inch pan head where a 1/4 inch should have been. Most of the screws on the rear panel are 1/4 inch long. There should be no flat-head screws on the bottom or the rear of the K3. You will need flat-head screws for the top cover if that is not already in place.
Good luck finding those little critters, they can be elusive on and under the workbench. 73, Don W3FPR Mike wrote: > It's just not my day.... > > Mike wrote: > >> Dang! It happened again... >> >> My upgraded DSP board came today, and I sat down to put the K3 back >> together. >> >> I have the bottom of the front panel and the front bottom cover left. >> >> I have 2 4-40 3/16 flat-head screws, 6 4-40 3/16 pan heads, and 1 pan >> head that looks like a 4-40 1/4. >> >> I can't determine what goes where and I can't find it in the assembly >> manual. None of the holes in the bottom cover, or the bottom of the >> front panel are beveled, so it looks like they should all be pan-heads. >> >> I've been over it 4 times now, and can't see anywhere I used the wrong >> screws anywhere. >> >> 73, Mike NF4L >> > ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
