Hello everyone again, Thanks for the quick replies on the K3 Utility errors I was having last night. 5W TX manual calibration worked just fine.
Now I've got my KPA3 installed, and when trying to run the manual 50 watt TX calibration procedure, after going in to Tune mode (pressing and holding XMIT/TUNE for 1 second), the display shows "- -" in VFO A and "0W" in VFO B. When I press XMIT/TUNE again to exit from Tune mode, VFO B reads ERR TXG. I have my FLTX set to FL1 ,which is the 2.7K filter, for all modes. I have run the Synthesizer calibration procedure already, as well as the Reference Oscillator calibration using Method 2 (zero-beating). Thoughts? 73 de Al, KE1FO ----- Check out my Amateur Radio Contesting blog at ke1fo.wordpress.com. ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
