Firmware & DSP versions?

On Tue, Apr 13, 2010 at 10:40 AM, Mike K2MK <[email protected]> wrote:
>
> My fist has been getting rusty so I've begun practicing sending CW by putting
> the K3 into TEST mode and sending paragraphs of text. I discovered that when
> going back to normal TX mode, the power output was drastically reduced. At
> first I thought I was accidentally turning the power knob to adjust keying
> speed so today I conducted a controlled experiment.
>
> I set the K3 keying speed to 23 WPM and did not readjust it. I found that it
> is necessary to send CW in TEST mode for about 5 minutes for the condition
> to occur. I tried it on 3 bands at 3 different power levels. In each case I
> noted the power before going into TEST mode and then after 5 minutes I noted
> the power after exiting TEST mode. The power was read on my PowerMaster
> meter into a dummy load but a touch of the K3 POWER knob confirmed that the
> K3 and the PowerMaster agreed with each other.
>
> Here's what I found.
>
> 17 meters: power reduced from 29 watts to 5.2 watts
> 20 meters: power reduced from 24 watts to 5.1 watts
> 30 meters: power reduced from 100 watts to 5.0 watts
>
> Give it a try.
>
> 73,
> Mike K2MK
> --
> View this message in context: 
> http://n2.nabble.com/K3-power-reduction-after-using-TEST-mode-tp4896438p4896438.html
> Sent from the Elecraft mailing list archive at Nabble.com.
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:[email protected]
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
>
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html

Reply via email to