Allan, You will not be able to achieve the 20 watts of the Argo V with the K2. Expect 12 watts to 15 watts depending on the band.
The winding of T1 and T2 are important to the power output on the higher bands, especially T2 which should be mounted about 1/8 inch above the board for best results. See the winding details in the new manual. 73, Don W3FPR Allan Taylor wrote: > I have recently purchased a very early K2 (S/N 152) and would like > reasonable suggestions on how to up slightly the output of the PA > stage. Recalling from way back when > I actually built a K2 (S/N 157, subsequently sold), the available > drive was affected by winding of toroids, selection of driver > transistor etc. I can't go class C as I have the > ssb module in the rig. My goal is to have the power level of the > Tentec Argonaut V but with the K2 receiver! My interests are entirely > portable/backcountry use. > > ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
