Hi John, You should be fine. Take your time and enjoy the build. Finish the one K2 before you start the other. It'll go a whole lot smoother when you know what to expect.
Also, I'd recommend you consider getting pre-wound toroids from Mike Morohovich ( 412) 481-2349 [email protected]. Toroids aren't much fun, and if the enamel isn't properly removed, any poor connections can lead to all sorts of grief. Cheers, Alan Alan D. Wilcox, W3DVX (K2-5373, K3-40) 570-321-1516 http://WilcoxEngineering.com Williamsport, PA 17701 John Fritze wrote: > I started build one of the 2 K2s I ordered at Dayton (one for me and > the second for Linda K2QYL). After about 5 hours I have the control > board done. I did the resistence measurments as specified and all are > OK, except for U6 pins 29 &30, the DIT and DAH pins. The manual > specifys between 70-90K ohms, I have 95K on both. I'm guessing that > is OK. Or do I need to look for something fairly minor? > > John > K2QY > ______________________________________________________________ > ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
