OK - Here is my problem, I should have worded it different. I bought an "open box" Linear and it came without any cables. So I guess I need to know what pins go to what pins.....I can get the connectors and build my own cable if I know what hooks where...I replaced the board in my K3 so I didn't have to do the pull-up resistor thing when I first hooked up the 1.5 unit PHIL. www.n2bee.net "Sometimes I think I understand everything, then I regain consciousness" ----- Original Message ----- From: Phil & Debbie Salas To: [email protected] Sent: Friday, May 28, 2010 11:55 AM Subject: Re: [Elecraft] ELECRAFT TO TOKYO HY-POWER 2.5
The THP2.5 uses a regular 15-pin D-connector, whereas the K3 uses the 15-pin HD D-connector. Nothing special needs to be done, other than finding the pin outs from the manuals. The THP 2.5 even has pull-up resistors so early K3 radios will drive the band data input just fine (NOT the case with the THP 1.5, where you need the K3 pull-up mod). If you plan on using ALC, you do need the K3 negative-going ALC mod if you have an early K3. Phil - AD5X ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
