Hi there. I suspect this may be the first of many questions and requests for
advice with my new K2...
First test (K2 manual page 43) revealed that I had stupidly omitted the U2 6V
regulator (thought missing from kit until today), so I got the 080 error
message.
Added this and did not get the 7100.00c display but 3030 with blinking A and
RIT indicators with r above XIT and sometimes a - (dash) above that, depending
on band selected.
Scrolling though the bands gives: various 3040/3028/etc frequency readings with
a 25023 and "turn 1" and "turn 2" appearing momentarily.
The relays are clicking with band selection and the display seems ok, although
I cannot get
ST L 040 but ST L 003 and not INP HAND only INP SCAN
One green bar at extreme right of S-meter.
Shaft encoder rate/direction and battery volts/current display are ok.
Are these related to firing it up first time without 6V U2?
What should I check?
Many thanks.
Ian
_________________________________________________________________
http://clk.atdmt.com/UKM/go/195013117/direct/01/
We want to hear all your funny, exciting and crazy Hotmail stories. Tell us now
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
