When was your K3 shipped? If it was shipped before Dec 22, 2008 you may need to apply this modification to your radio: http://www.elecraft.com/K3/mods/ELECRAFT_Application_Note_KSYN3_ALC_Rev_A.pdf
~Brett (N7MG) On Wed, 2010-06-09 at 21:02 -0400, Gary Smith wrote: > Hi, > > Haven't been on the air much, the K3 has been unplugged & antennae > disconnected just to protect against lightning possibilities. Last I > used the rig, I was mostly on the lower bands, rarely 15 meters or > above. > > just for fun I went to check my butternut HF9V to see if there were > any issues on the bands and when I went to 12 meters I get ERR PL 1 > and on 10 meters I get the same flash message and there's no > transmit. 6 meters is fine as are all other bands. this is confined > to 12 & 10 meters. > > I reloaded the current firmware and get the same result. I used the > elecraft utility to calibrate the transmit thinking that might be the > issue but it failed when it got to 24Mhz. > > Idears? > > Thanks, > Gary > KA1J > ______________________________________________________________ > Elecraft mailing list > Home: http://mailman.qth.net/mailman/listinfo/elecraft > Help: http://mailman.qth.net/mmfaq.htm > Post: mailto:[email protected] > > This list hosted by: http://www.qsl.net > Please help support this email list: http://www.qsl.net/donate.html ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
