Joe, Just been playing with this some more and there does seem something odd about 28MHz.
If I do as you instruct the swr does indeed now indicate 1:1 on bypass to a dummy load. However if I turn on the ATU and 'tune' it to match to an antenna and then go back and check bypass into the dummy load I get a high reading again. It's as if invoking the ATU to match the antenna is wiping the 50 ohm setting previously set up - all other bands seem fine. ANT1 and 2 behave the same...TUNE power by the way is 10 watts. Stewart, GW0ETF Joe Subich, W4TV-4 wrote: > > > Stewart, > > The K3ANT does not do a "hard" bypass. Instead it sets the > tuner to the memorized 50 Ohm : 50 Ohm position. > > Since the tuner memories are "by band" and "by antenna" - plug > the dummy load into the ANT 1 position, enable the tuner and > hit the "ATU Tune" button. That will "teach" the tuner the 50 > Ohm setting for ANT 1 and you won't see the issue in the future. > > 73, > > ... Joe, W4TV > -- View this message in context: http://elecraft.365791.n2.nabble.com/K3-Odd-SWR-readings-ANT1-v-ANT2-tp5169157p5176659.html Sent from the [K3] mailing list archive at Nabble.com. ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:Elecraft@mailman.qth.net This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html