I've made significant changes to the K3 Utility over the last few weeks to exploit new MCU capabilities, and I need a few volunteers to test before offering this version for general availability.
I need people to test firmware load, TX calibration, RF Gain calibration, configuration save/restore and crystal filter configuration. All functions that access K3 EEPROM (config save/restore, filter configuration, command macro read/write) are much faster. For example, save configuration takes 5 seconds. Tx Gain calibration no longer changes the last-used frequency on each band. The new Tx Gain calibration uses different techniques for MCU >= 3.97 and earlier than 3.97. I need some testers for both before and after 3.97. If you can help, please send a note to [email protected] or [email protected]. Thanks! Dick, K6KR ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
