Hi all, I am working through the last stage in transmitter alignment - page 80 - and I've come across a problem. All goes smoothly until I switch to 10m. There I can maximize power output, but only to 1.9 W or so, so just shy of the 2 W target by adjusting L12 and L13. When I switch to 12, there is no output registered once I switch over to "Tune". Adjusting C44 and C46 has no noticeable effect.
I've made a careful inspection of the circuit board, and I don't see anything obvious. I was wondering if someone here could help me localize the problem? I was able to listen to some CW on 12m, but it wasn't a very strong signal. I'm listening on a buddistick inside my house, so I don't think I can expect much. Thanks for any guidance, Joe KC8YFH K2 sn 6773 ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
