Hi Tom: I troubleshoot peculiar K3 occurrences in this order. 1. Operator error 2. Computer error 3. K3 error
It sounds like item 1 is ok. Move to item 2. Turn off any logging program or better yet disconnect the serial cable. 73, Mike K2MK Tom Boucher wrote: > > Can anyone throw any light on the following way in which my K3 has always > behaved? > > Using memories 00 - 09 as if they were band switches: Config: Mem 0-9 : > Band Sel > Memories 00 - 09 are each set up on a frequency in each band using the V>M > button. > Tap M>V button, then select a memory either by rotating VFO A or by > tapping buttons 0 - 9, then tap M>V again. > Band is selected correctly but VFO A is locked up and won't change > frequency until another button is pushed (e.g. Freq Ent, Fine or Rate) > > It's not a major problem but am I doing something wrong? > > 73 > Tom G3OLB > K3 S/N: 01434 with FW v. 3.97 > ______________________________________________________________ > Elecraft mailing list > Home: http://mailman.qth.net/mailman/listinfo/elecraft > Help: http://mailman.qth.net/mmfaq.htm > Post: mailto:[email protected] > > This list hosted by: http://www.qsl.net > Please help support this email list: http://www.qsl.net/donate.html > > -- View this message in context: http://elecraft.365791.n2.nabble.com/K3-Memory-Recall-tp5225405p5225458.html Sent from the Elecraft mailing list archive at Nabble.com. ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
