Hi My K2 used to receive nicely. Good strong signals on various bands, I was able to use a noise generator and spectrograph program to tune the filters, etc. Then I added the ssb kit and receiving seemed to fall way off. I removed the kit, re-soldered the jumpers and resistor and still receiving is bad. I can hear occasional signals, but nothing makes the S meter move. I can hear a slight difference between the noise generator being on and off, but not enough to get a hump on the spectrograph. A sad state.
So I'm going to embark on a signal tracing adventure, but I have a question: The instructions say the signal generator should be outputting .14 Vrms according to the RF probe - is that reasonably accurate? If I use an oscilloscope instead should I be getting .14Vrms (.2Vp or .4Vpp)? That seems high when the s9 reading corresponds to 50 uV.. I just want to make sure I'm not going to fry something pumping in 200000 uV. Thanks Robert K6RJG ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
