Thanks Tom, I have the later version, will check with relays it have.
Will install it, taking care of the amp relay control. I have the diagram to connect it right. Thanks ! 73, Jorge CX6VM/CW5W -----Mensaje original----- De: Tom W8JI [mailto:[email protected]] Enviado el: Martes, 13 de Julio de 2010 11:37 a.m. Para: Jorge Diez - CX6VM; 'Elecraft Reflector' Asunto: Re: [Elecraft] continuous relay click in RX ANT IN > Seems is similar to this made from ICE, at least will add extra protection > to the K3, what do you think? > > Or it will decrease the RX signals I can receive in the K3? As far as I know that unit uses reed relays, and should have no detectable loss. I think there might be two models of that, but I have only seen a reed relay version. The advantage of the one I saw is the low loss and no signal distortion using relays. You must run the amplifier relay control through it to be sure the protection sequence is correct. 73 Tom ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
