I have been playing with the K2 DSP a good bit of the day and trying to get the noise reduction settings programmed.
>From reading the "Assembly and Operating Instructions", there are 4 noise reduction filters and these are independent of the DSP CW filter settings. I can select a CW filter and change the selected noise reduction filter. What I cannot seem to do is set the noise reduction parameters for each n1...n4 and save those parameters. Programmatically, accessing the various DSP parameters does not seem to be doable. All that I have found are the SW80 and SW81 commands. Is there a "How to" guide for the DSP module? If not, what have others done? The "Operating Instructions", while good to read, seem to gloss over a lot of the user procedures and leave a lot to be desired in comparison to the usual Elecraft manuals. Any help would certainly be appreciated. Jay AJ4AY Mobile, AL ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
