Thanks for the report. I have reverted the Antenna check code to be what
it was in version 9.05, and your example now works. This code is in the
Savannah repository, but is not released. You will have to build it
yourself.
-Steven Rubin
On 12/4/2016 5:05 AM, Estevao Teixeira wrote:
Hello,
I have done the antenna rule checking in the version 9.07 of Electric,
using the test library attached.For the cell "test_antenna1", an error
was expected, and it was notified by the Electric. For cell
"test_antenna2", an error message was not expected, since the long
metal line is connected to a diffusion. However, Electric showed an
antenna error message even for this cell.
In comparison, at version 9.06 no antenna error messages are shown,
because antenna test is not working for that version.
Version 9.05 showed the expected messages: error for cell
"test_antenna1", no error for cell "test_antenna2".
I think version 9.05 remains as the recommended version for antenna
rules checking, and this feature should be revised at version 9.07.
Regards,
Estêvão
--
You received this message because you are subscribed to the Google
Groups "Electric VLSI Editor" group.
To unsubscribe from this group and stop receiving emails from it, send
an email to [email protected]
<mailto:[email protected]>.
For more options, visit https://groups.google.com/d/optout.
--
You received this message because you are subscribed to the Google Groups "Electric
VLSI Editor" group.
To unsubscribe from this group and stop receiving emails from it, send an email
to [email protected].
For more options, visit https://groups.google.com/d/optout.
