there have been cases of replacing the u35 did not resolve the issue and there was an additional chip that also needed to be replaced. unfortunately i do not remember the specific chip nor the thread title that mentions it . all i can suggest to to do a strong search of the list past or maybe someone else who knows more will chime in.
On Fri, Jul 21, 2017 at 8:12 AM, Daniel Stjernholm Andersen < [email protected]> wrote: > Hello, > > I have the MB TurboT 2210, rev. F200. I gave it 12V, and that fried the > U35 chip :(. > > I read various posts that it should be fixable, and I ordered a new chip. > When desolderen the old one, I accidentially damaged some pads. To work > around that, I have run 2 jumperwires from pin 5 to R47 DDR_SMB_DATA, and > from pin 7 to R289. > > Unfortunately, the board will not boot. D1 is solid, but D2 either flashes > rapidly for some seconds, or stays solid for 2-4 seconds, and then it turns > off. No output on the screen. > > Have you guys got any idea what the problem could be, and if it can be > solved? > > I did two small videos of the power on attempts: > https://youtu.be/477rLoZN7-c > https://youtu.be/HU3SsF51ZeU > > Best regards, > Daniel > > _______________________________________________ > elinux-MinnowBoard mailing list > [email protected] > http://lists.elinux.org/mailman/listinfo/elinux-minnowboard >
_______________________________________________ elinux-MinnowBoard mailing list [email protected] http://lists.elinux.org/mailman/listinfo/elinux-minnowboard
