What about :results code The default is a elisp code block so you get syntax coloring
On Wed, Jun 23, 2021, 16:22 Rodrigo Morales <moralesrodrigo1...@gmail.com> wrote: > Johannes Brauer <bra...@nordakademie.de> writes: > > Johannes Brauer writes: > > > thanks, that works > > While that works, you might be interested in ":results verbatim" instead > of ":results raw" since when using "verbatim" the results are replaced > when re-evaluating the code block. See minimal working example below. > > After pressing =C-c C-c= five times > > #+BEGIN_SRC elisp :results raw > (list 1 2 3) > #+END_SRC > > #+RESULTS: > (1 2 3) > (1 2 3) > (1 2 3) > (1 2 3) > (1 2 3) > > After pressing =C-c C-c= five times > > #+BEGIN_SRC elisp :results verbatim > (list 1 2 3) > #+END_SRC > > #+RESULTS: > #+begin_example > (1 2 3) > #+end_example > > PS: If you haven't customized Org Mode enough, you might get a ":" as > the prefix of some of your results. > > #+BEGIN_SRC elisp :results verbatim > (list 1 2 3) > #+END_SRC > > #+RESULTS: > : (1 2 3) > > As can be seen above, the results are not enclosed within > #+begin_example and #+end_example. To enable this, set the following. > > #+BEGIN_SRC elisp > (setq org-babel-min-lines-for-block-output 0) > #+END_SRC > > Once you set the option shown above, you might get the following when > evaluating the code block. > > #+BEGIN_SRC elisp :results verbatim > (list 1 2 3) > #+END_SRC > > #+RESULTS: > #+begin_example > (1 2 3) > #+end_example > >
