On Fri, Mar 22, 2013 at 10:27 AM, Nicolas Goaziou <[email protected]> wrote: > Hello, > > John Hendy <[email protected]> writes: > >> In the past, exporting a subtree seemed to pull options from my >> #+setupfile line. > > And it should still do. > >> I've updated the line to the proper new syntax (#+include: >> "/path/to/setupfile.org"), but subtree export doesn't seem to be using >> the options set there (using =C-c C-e C-s l p= for LaTeX/PDF export). >> >> I tried using =#+include: "file"= as well as =#+setupfile: file= >> inside the subtree properties drawer without success. > > Inside the property drawer? A property drawer can only contain node > properties, e.g.: > > :PROP: value
Yeah, I didn't really know... was just going by this recent post which featured that, so since it was fresh in my mind, I tried: - http://www.mail-archive.com/[email protected]/msg68321.html > >> If I mark the same subtree with :export: tag (no other trees are >> marked), it works properly and uses my setupfile options. >> >> Any suggestions? If this was an oversight, my vote would be that a >> buffer-set setupfile would apply to subtree exports unless overridden >> by a property-drawer setting (even though I don't currently know that >> the property draw setting is for a setupfile). > > I think I need an ECM to understand the problem you're describing. Sure. Try this: #+begin_src setupfile #+AUTHOR: John Henderson #+latex_header: \usepackage[hmargin=2.5cm,vmargin=2.5cm]{geometry} #+latex_header: \usepackage{mathpazo} #+end_src #+begin_src test-setupfile.org #+include: "/path/to/setupfile" * Heading 1 Some text in the form of a longer paragraph to test the margin settings using the =geometry= package. Some text in the form of a longer paragraph to test the margin settings using the =geometry= package. Some text in the form of a longer paragraph to test the margin settings using the =geometry= package. List: - item 1 - item 2 - item 3 #+end_src #+begin_src minimal-config ;; set load paths ;; set load dirs and global config options (add-to-list 'load-path "~/.elisp/org.git/contrib/lisp/") (add-to-list 'load-path "~/.elisp/org.git/lisp/") (require 'ox-latex) #+end_src Procedure: - emacs -Q - M-x load-file minimal-config - C-x C-f setupfile-test.org - Now compare the results of =C-c C-e l p= vs. (while on * Heading 1) =C-c C-e C-s l p=. Best regards, John > > > Regards, > > -- > Nicolas Goaziou
