>
> 1) What is the cost for me to use the code, change it, and make it
> closed to my customer ? Or if this can be legally done ?
> 2) If I can continue to use, as I am now, controlling the servo drives
> directly from the parallel port ?
> 3) If the tool tip radius compensation is implemented and working on EMC
> (lathe mode XZ plane)?
> 4) If some tool table is implemented and working ?
>
2) all depends on your electrical specifications.
4) EMC/EMC2 is also used on machines which have automatic tool changers and
even if you do manual tool change, tool tables are fully implemented from
the very beginning, you have to see the manual.
-------------------------------------------------------------------------
This SF.net email is sponsored by: Microsoft
Defy all challenges. Microsoft(R) Visual Studio 2008.
http://clk.atdmt.com/MRT/go/vse0120000070mrt/direct/01/
_______________________________________________
Emc-developers mailing list
[email protected]
https://lists.sourceforge.net/lists/listinfo/emc-developers
