Bugs item #1909216, was opened at 2008-03-07 02:14 Message generated for change (Tracker Item Submitted) made by Item Submitter You can respond by visiting: https://sourceforge.net/tracker/?func=detail&atid=106744&aid=1909216&group_id=6744
Please note that this message will contain a full copy of the comment thread, including the initial issue submission, for this request, not just the latest update. Category: GUI - AXIS Group: None Status: Open Resolution: None Priority: 5 Private: No Submitted By: Michael (micges) Assigned to: Chris Radek (cradek) Summary: Error allowing send MDI command while running program Initial Comment: Small combination of actions taken while program running cause execution of program hang on last line of gcode when it's M2 or execute MDI command if it isn't. actions taken to reproduce error: run emc sim_mm.ini key F1 key F2 key F5 send mdi "G1 X10" key r waiting few seconds key r key ENTER to close error message click on last line of MDI history key ENTER (now should be error message that we attempt to send MDI while running, there is no message) Program will stop executing on line M2 and interpreter will be in waiting state. If gcode loaded will not have last line M2, then MDI command sended while running program will be executed right after program end. ---------------------------------------------------------------------- You can respond by visiting: https://sourceforge.net/tracker/?func=detail&atid=106744&aid=1909216&group_id=6744 ------------------------------------------------------------------------- This SF.net email is sponsored by: Microsoft Defy all challenges. Microsoft(R) Visual Studio 2008. http://clk.atdmt.com/MRT/go/vse0120000070mrt/direct/01/ _______________________________________________ Emc-developers mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-developers
