Bugs item #1922330, was opened at 2008-03-21 11:19 Message generated for change (Tracker Item Submitted) made by Item Submitter You can respond by visiting: https://sourceforge.net/tracker/?func=detail&atid=106744&aid=1922330&group_id=6744
Please note that this message will contain a full copy of the comment thread, including the initial issue submission, for this request, not just the latest update. Category: EMC2 Motion Controller Group: None Status: Open Resolution: None Priority: 5 Private: No Submitted By: Chris Radek (cradek) Assigned to: John Kasunich (jmkasunich) Summary: arcs with large radius result in wrong motion Initial Comment: This valid arc should generate nearly a straight line move. This program previews correctly in AXIS. When run, the tool heads in the correct direction but goes too far. In AXIS the DTG shows about 16542232161 inches. It should be about 1. g17 g20 g0 x0 y0 g3 y1 i-2632778018.2 j.5 f10 m2 ---------------------------------------------------------------------- You can respond by visiting: https://sourceforge.net/tracker/?func=detail&atid=106744&aid=1922330&group_id=6744 ------------------------------------------------------------------------- This SF.net email is sponsored by: Microsoft Defy all challenges. Microsoft(R) Visual Studio 2008. http://clk.atdmt.com/MRT/go/vse0120000070mrt/direct/01/ _______________________________________________ Emc-developers mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-developers
