Feature Requests item #1926697, was opened at 2008-03-26 21:01 Message generated for change (Tracker Item Submitted) made by Item Submitter You can respond by visiting: https://sourceforge.net/tracker/?func=detail&atid=356744&aid=1926697&group_id=6744
Please note that this message will contain a full copy of the comment thread, including the initial issue submission, for this request, not just the latest update. Category: None Group: None Status: Open Resolution: None Priority: 5 Private: No Submitted By: Greg (cadmonkeyinohio) Assigned to: Nobody/Anonymous (nobody) Summary: Z Jog while porgram paused for toolchange Initial Comment: For those of us with R8 tooling (or most any collet tooling) being able to adjust the 0 of the Z axis would be very beneficial. I don't see any way to do this in the documentation, and tool length offsets are too variable with collets. I'd like to put a simple touch off height block on the table at the toolchange location and zero each tool at the toolchange and continue to program. ---------------------------------------------------------------------- You can respond by visiting: https://sourceforge.net/tracker/?func=detail&atid=356744&aid=1926697&group_id=6744 ------------------------------------------------------------------------- Check out the new SourceForge.net Marketplace. It's the best place to buy or sell services for just about anything Open Source. http://ad.doubleclick.net/clk;164216239;13503038;w?http://sf.net/marketplace _______________________________________________ Emc-developers mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-developers
