you might consider switching to gladevcp for less dangerous results. This particular issue was addressed here - see Section 10: http://www.linuxcnc.org/docs/devel/html/gui/gladevcp.html#_implementation_note_key_handling_in_axis
-mah Am 12.11.2011 um 13:41 schrieb John Thornton: > On my plasma when I type a number into the spinbox and tweak the up/down > key to make it take the number the spinbox text area keeps the focus > from the key board even after you tweak the up/down key. Many a time > when EMC would not run my program I look a the spinbox and see "81rrr" > and start clicking on different tabs till the focus leaves the spinbox. > I think I'll try a slider to see if if works better for me. > > John > > On 11/12/2011 6:21 AM, andy pugh wrote: >> On 12 November 2011 06:03, Chris Morley<[email protected]> wrote: >> >>>> There was a patch that mapped "enter" to spinboxes in pyVCP, >> ... >>>> Is there a reason that that has never made it into a released branch? >>> Yes I believe it was because it stole focus and left hitting estop (ESC) >>> impossible so was deemed dangerous. >> However, it doesn't stop you typing numbers in the box, just makes it >> tedious and/or misleading so I am not entirely sure that the logic >> stacks up. >> I wonder if it would be possible to map "esc" into "lose focus,then esc"? >> > > ------------------------------------------------------------------------------ > RSA(R) Conference 2012 > Save $700 by Nov 18 > Register now > http://p.sf.net/sfu/rsa-sfdev2dev1 > _______________________________________________ > Emc-developers mailing list > [email protected] > https://lists.sourceforge.net/lists/listinfo/emc-developers ------------------------------------------------------------------------------ RSA(R) Conference 2012 Save $700 by Nov 18 Register now http://p.sf.net/sfu/rsa-sfdev2dev1 _______________________________________________ Emc-developers mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-developers
