I am using a mm setup and I was not able to get any combination of delta, depth, mill size, or pocket size to work after many attempts. Thus, I figured this was just broken and commented out. here is an example, using a 10mm diameter mill
o<qpocket> call [5][1000][2][300][5][2.5][0.2][0][-30][-30][-30][30][30][30][30][-30][1][0][0][0][0.01][0.002][0][0] |G0 X [- #<col_boltx> ] Y [ #<col_boltyt> ] it errors with the "Tool radius not less than arc radius with comp" Also, I played with tdelta increasing and decreasing it. Sometimes it would allow this error to go away (i.e. the entry would be ok) but then there would still be the problem with the path going back to center on the next layer. That would say the part would be gouged. > ------------------------------ Message: 4 Date: Sun, 26 Jan 2014 > 17:51:23 +0000 (UTC) From: Dewey Garrett <[email protected]> Subject: > Re: [Emc-developers] Emc-developers Digest, Vol 93, Issue 44 To: > [email protected] Message-ID: > <[email protected]> >> ok, so... if I delete those / it will enable the code and I get the >> errors... same thing as toggling / line support, isn't it ? > It would be helpful if you could identify the exact error message > and enough information to repeat the error: the corners of the > quad, the tool diameter, etc (e.g., qpocket parameters 1 thru > 24) > > I was able to use quad corner values that resulted in this > error: > "Tool radius not less than arc radius with comp" > > This one may relate to a calculation roundoff error -- I increased tdelta > from .00001 to .0001 and the case ran. This was for an inch setup, > it may be different for mm. > > ------------------------------------------------------------------------------ CenturyLink Cloud: The Leader in Enterprise Cloud Services. Learn Why More Businesses Are Choosing CenturyLink Cloud For Critical Workloads, Development Environments & Everything In Between. Get a Quote or Start a Free Trial Today. http://pubads.g.doubleclick.net/gampad/clk?id=119420431&iu=/4140/ostg.clktrk _______________________________________________ Emc-developers mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-developers
