I tried reducing the G64 values, I also set G61. I also tried running it at very slow feed rate. I increased the maximum velocity of each axes and also the acceleration in the INI (in case it matters in the sim)
No change, the path goes way past the previewed path. I do not see any difference in the path followed when I change any of the parameters above. I tried in linuxcnc 2.5.3, 2.5.4, 2.6 pre3 sim, axis mm config. I do understand that it looks like the path is going out like preparing for the following curve, so it could be some machine limit thing (and I am crossing my fingers that it is), but G61, G64 should affect it in this case. Really at a loss on this one. On 5/30/14 8:03 PM, [email protected] wrote: >> Thanks ! >> >Bruno >> > > At first glance it looks like the machine aceleration limits are not being > followed or G64 mode issue. Have you tried G64 Px.xxx? > > >> > > Peter Wallace > Mesa Electronics ------------------------------------------------------------------------------ Time is money. Stop wasting it! Get your web API in 5 minutes. www.restlet.com/download http://p.sf.net/sfu/restlet _______________________________________________ Emc-developers mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-developers
