Hello Guys,
Trying not to push the envelope too far, We have implemented Andy's Fanucy tool remap into our configuration on one of our turning centers, and it is a tremendous improvement in regards to some of the things we have been pushing since the inception of LinuxCNC in our shop. It will be going on all machines as soon as I can get my hands them. Thank You One of the few things we have been wondering about though is if there is an ability to make a separate table/tab to be able to put those wear offsets in instead of the main tool table. This helps safeguard fat fingering the main tool data/numbers against having them changed, and having to go and re-touch off your tools when a mistake like that is made. Just an honest question, about whether or not it is possible, we here know all of you guys are hard at work doing what you can to improve the LinuxCNC project, and a lot of things take precedent over minor things like this. Thanks Rick Lair Superior Roll & Turning LLC. PH: 734-279-1831 www.superiorroll.com ------------------------------------------------------------------------------ Infragistics Professional Build stunning WinForms apps today! Reboot your WinForms applications with our WinForms controls. Build a bridge from your legacy apps to the future. http://pubads.g.doubleclick.net/gampad/clk?id=153845071&iu=/4140/ostg.clktrk _______________________________________________ Emc-developers mailing list Emc-developers@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/emc-developers
