Ah Andy so now I am not the only one feeling the pain of this. I asked the question a couple of weeks back on how to get back to manual mode after running and MDI command. There was some answers that made sense on that thread. If you dont clean up your mailbox regularly it should still be there. The subject was Getting back to MANUAL mode after MDI or AUTO
On 2015-01-12 03:39, andy pugh wrote: > I recently had a problem with the HD on my lathe, and just swapped out > the drive and did a liveCD install to 2.6.4 > > My Lathe mainly uses my GladeVCP panels that call G-code subs using > the "MDI button" control. > > With the new version the MDI button GladeVCP control switches Axis to > MDI mode, and thet means that one can't then jog the machine without > switching to manual mode. > > This was not previously the case. I can see the reasoning. But it's a > bit annoying. I guess that what is happening is that Axis is more > accurately mirroring the global mode state than it did. > > So, perhaps the GladeVCP controls need to switch back to the previous > mode when they have done their thing? > -- Regards /Groete Marius D. Liebenberg +27 82 698 3251 +27 12 743 6064 QQ 1767394877 ------------------------------------------------------------------------------ New Year. New Location. New Benefits. New Data Center in Ashburn, VA. GigeNET is offering a free month of service with a new server in Ashburn. Choose from 2 high performing configs, both with 100TB of bandwidth. Higher redundancy.Lower latency.Increased capacity.Completely compliant. vanity: www.gigenet.com _______________________________________________ Emc-developers mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-developers
