On Saturday 15 August 2015 14:29:35 Andy Pugh wrote: > > On 15 Aug 2015, at 18:06, Gene Heskett <ghesk...@wdtv.com> wrote: > > > > FWIW, G20 mode (inches) is in effect, but a 6.35 for tool D in > > tool.tbl makes it normally visible as a 1/4" mill. So the tool.tbl > > entries are being treated as milimeters. > > What does the INI have as machine units?
I hadn't thought to look at that, under the [TRAJ] LINEAR_UNITS = mm There is no gcode preamble, its all in the gcode I'm feeding it as line 2. So I have to assume that .ini entry is the cuplrit, it just wasn't on my list of usual suspects. Thanks Andy. And I finally got the g-code behaving itself, so I am about to go order some more Mahogany. One file, with 2 variables changed at the top of it, carves all the joints for either the top foot, or the 3.5" wide baseboard skirt of this blanket chest. So right now, I'm a happy camper. Time to go clean up the midden heap and make some working room. It is as usual, is in short supply. I see at least 2 trips to the landfill with my 4x8 foot trash trailer since its already full. Cheers, Gene Heskett -- "There are four boxes to be used in defense of liberty: soap, ballot, jury, and ammo. Please use in that order." -Ed Howdershelt (Author) Genes Web page <http://geneslinuxbox.net:6309/gene> ------------------------------------------------------------------------------ _______________________________________________ Emc-developers mailing list Emc-developers@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/emc-developers
