On 9 January 2016 at 20:46, Fernand Veilleux <[email protected]> wrote:
> My BOB is this one : > http://www.omc-stepperonline.com/5-axis-cnc-breakout-board-interface-for-stepper-motor-driver-stv2-p-197.html > My VFD manual is here : > http://www.hclub.ee/download/varia/KOC100%20Series%20User%20Manual--20150119%28V1.1%29.pdf > > lcnc gives the options of : analog signal OR pwm. In stepconf it is the same thing. There is no analogue output from a parallel port. The BoB manual isn't as clear as it could be, but the 0-10V output from the spoindle connector looks to be controlled by a PWM on pin 1 of the parport. So if you set up pin 1 to be a spindle PWM in stepconf, then it ought to be pretty close to working. -- atp If you can't fix it, you don't own it. http://www.ifixit.com/Manifesto ------------------------------------------------------------------------------ Site24x7 APM Insight: Get Deep Visibility into Application Performance APM + Mobile APM + RUM: Monitor 3 App instances at just $35/Month Monitor end-to-end web transactions and take corrective actions now Troubleshoot faster and improve end-user experience. Signup Now! http://pubads.g.doubleclick.net/gampad/clk?id=267308311&iu=/4140 _______________________________________________ Emc-developers mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-developers
